Mon–Sat 10:00–20:00 UTC+8 [email protected]
Email us

Custom ECU & TCU calibration · Remote for shops worldwide

Stage 3 on
any platform

One tuner who reads the ECU, writes the file, verifies it on our own DynaLink chassis dyno, builds the hardware and races the result. BMW, Audi, Porsche, Honda, Subaru, Toyota, Hyundai.

Send a datalog How it works
475 → 583 PSAudi RS7 C8 · at the wheels
634 → 778 NmAudi RS7 C8 · at the wheels
1,000+vehicles tuned
4,600+calibration files on record

On the dyno

Custom calibrations, run by run on our DynaLink chassis dyno. More on our YouTube channel.

Cases

The hardware, the problem, what we did, the result. Numbers from our DynaLink dyno unless stated.

Stage 2 + intercooler

Audi RS7 Sportback performance (C8)

4.0 TFSI · Wagner Tuning intercooler · engine re-tune · RON 98

475 → 583 PS · 634 → 778 Nmat the wheels · +23%

With the new intercooler the car was still on the conservative map for the stock unit. Bumper off, intercooler in, coolant change, back on the dyno. Lower intake temperature leaves room to advance timing: +21 to +32 PS over Stage 2 from 4,500 to 6,000 rpm.

Stage 3

BMW 1M Coupé (E82), N54

Hybrid turbos · Do88 intercooler, radiator, piping · BMS manifold · APT water-meth · VTT crank hub · 3.5 bar MAP · RON 98

295 → 402 PS · 435 → 536 Nmat the wheels, SAE corrected · est. crank 464 PS / 615 Nm

Arrived with cruise control dead after an earlier DME software-version change. We restored the factory software, rebuilt the calibration on it with no third-party code, fixed the water injection, and put it back on the dyno. Cruise control works.

Engine swap

Subaru BRZ (ZC6), FB25 2.5 swap — our own car

FA20 2.0 → FB25 2.5 · EcuTek custom calibration

2025 ZC Time Attack Group B champion1′42.6 · over a year of daily driving

The knock sensor sits elsewhere on the FB25, so knock scaling, throttle and idle were all re-done for the new engine.

Dyno chartDynaLink chart: our FB25 swap, solid, against an FA24 on 98-octane fuel, dashed

Our FB25 swap, solid, against an FA24 on 98-octane fuel, dashed. DynaLink dyno.

Services

Engine and gearbox tuned together, for your hardware, your fuel and your climate.

Custom ECU / TCU calibration

Engine and gearbox as one system. Shift points, torque limits per gear, throttle feel, all set for the hardware on the car.

Stage 1 to Stage 3

From a clean Stage 1 to big-turbo builds with upgraded intercoolers, fuel systems and water-methanol, integrated and verified on the dyno.

Engine swaps and deep builds

Unusual combinations made stable: knock scaling, idle, throttle and protection re-done for the new engine, not just a power map.

Datalog analysis

Send a log from any car you are working on. We tell you what it says: knock, timing, boost control, fuel trims, temperatures. First one is free.

How remote tuning works

Your shop keeps the car and the customer. We do the calibration. Stage 1 and Stage 2: same-day turnaround at the fastest, in any time zone.

Tell us the car

Model, engine, gearbox, hardware fitted, fuel available. We confirm what is possible before anything is flashed.

Read & flash at your shop

Autotuner, bFlash, BitBox, PCMFlash, bootmod3, MHD or your own tool. We send the file, you flash it. No tool? We ship one.

Log & iterate

Send datalogs from the dyno or the road. We revise the same day. As many rounds as it takes.

Sign off with numbers

Before and after dyno curves, datalog comparison, and a written report you can hand to the customer.

Platforms & tools

BMWMINIAudiVWPorscheHondaSubaruToyotaHyundai N ·bootmod3MHDMG FlasherEcuTekHondataKTunerWinOLS ·AutotunerbFlashBitBoxPCMFlash
Yichuan Lin, founder and head tuner

Racing record

  • 2025 ZC Time Attack, Zhejiang International Circuit: Group B champion, 1′42.6
  • Tianma Circuit time attack: M4 CS class champion
  • Tianma Citizens' Cup: champion
  • Tianma touring car open (天馬論駕): champion
  • Ningbo International Circuit, BRZ one-make series: 3rd overall
  • Twelve years racing at Tianma; fastest MK8 GTI there, 1:13.1

The tuner

Yichuan Lin, founder and head tuner, tuning for more than ten years. One person does the whole job: no file passed between a sales desk, a remote "master tuner" and a mechanic. You talk to the person who wrote your file.

  • Stage 3 is the specialtyBig-turbo and hybrid-turbo builds, fuel systems, engine swaps. The challenging jobs other tuners lack the skill or the time to take on.
  • Reads, writes, verifies, builds, drivesHands-on for over ten years, on every platform listed below.
  • Own chassis dynoDynaLink. Every file pulled before and after, with a written report.
  • Races what he tunesTwelve years of racing, multiple championships; full record on the left.
  • All the serious toolsbootmod3, MHD, MG Flasher, EcuTek, Hondata, KTuner, WinOLS.
  • 1,000+ vehicles, 4,600+ files on recordReads, versions and deliveries are kept. Ask about your engine code; the answer comes from records, not memory.
  • Built to stay reliableHis own ZC6 BRZ has run its FB25 2.5 swap for over a year, daily and to a championship. Our track cars race season after season without a single failure.

In numbers

10+years tuning
1,000+vehicles tuned
4,600+calibration files
12years racing
200k+followers*

* Combined followers across Douyin, Bilibili, Xiaohongshu, WeChat Channels and YouTube, November 2026. · Files on record: reads, versions and deliveries across all tools, counted November 2026.

SpeedUPRACING

Proven on track

Our files are not only dyno numbers. For more than ten years they have been driven flat out on track, in our own cars and our customers' cars.

Group photo of a SpeedUP track day with a line of cars on the grid
2023 · Tianma Circuit
Drivers and cars lined up on the starting grid
2023 · Tianma Circuit
Night track session, drivers in front of their cars
2017 · Night session
Track day group photo at Wantrack Circuit
2016 · Wantrack Circuit
BMW M3 drifting on the wet skid pad
BMW Driving Experience Centre
Karting race group photo in an indoor kart hall
2017 · Karting race
Karting team in racing suits
2017 · 3-hour karting endurance
Karting endurance finishers with medals
2017 · Karting endurance
Aerial group photo with cars on track
2016 · Tianma Circuit
BMW M4 in the pit lane at Shanghai International Circuit
BMW M Driving Experience · Shanghai International Circuit
Ferrari 458 on track at Shanghai International Circuit
2020 · Shanghai International Circuit
Chevrolet Camaro on track at Shanghai International Circuit
2020 · Shanghai International Circuit
Group photo: 2016 · Open race
2016 · Open race
Group photo: 2016 · Wantrack Circuit
2016 · Wantrack Circuit
Group photo: 2016 · Night session
2016 · Night session
Group photo: 2016 · Karting
2016 · Karting
Group photo: 2016 · Karting race
2016 · Karting race
Group photo: 2017 · Karting endurance
2017 · Karting endurance
Group photo: 2017 · Night session
2017 · Night session
Group photo: 2017 · Night session
2017 · Night session
Group photo: 2017 · Karting endurance
2017 · Karting endurance
Group photo: 2017 · 12-hour karting endurance
2017 · 12-hour karting endurance
Group photo: 2017 · 12-hour karting, night
2017 · 12-hour karting, night
Group photo: Karting
Karting
Group photo: 2020 · Track day
2020 · Track day
Group photo: 2020 · Tianma Circuit
2020 · Tianma Circuit
Group photo: 2020 · Tianma Circuit
2020 · Tianma Circuit
Group photo: 2020 · Track day
2020 · Track day
Group photo: 2022 · Tianma Circuit
2022 · Tianma Circuit
Group photo: 2022 · Tianma Circuit
2022 · Tianma Circuit
Group photo: 2023 · Tianma Circuit
2023 · Tianma Circuit
Group photo: 2023 · Tianma Circuit
2023 · Tianma Circuit
  • 1,000+ track daysOrganised over more than ten years at Tianma, Shanghai International Circuit and Zhejiang International Circuit. Full load, lap after lap.
  • 100+ karting racesSprint and endurance races, including three-hour team events.
  • BMW Driving Experience Centre partnerStrategic partner of the centre, operated by Lisheng Racing.

Questions customers actually ask

Taken from the questions we get most often. Short answer first.

How long does a tune take, and do I need to book?

A Stage 1 custom tune on our dyno takes 2 to 3 hours when everything goes to plan. If the ECU needs unlocking or cloning first, allow a day: cloning runs into the evening and the calibration is done the next day.

Remote: you flash when ready, we revise the same working day. Book ahead either way.

How much power will I gain?

It depends on the engine, the hardware and the fuel, so we quote per car, not from a table. Every car is measured before and after on our DynaLink dyno and you get both curves.

If the file you already have is close, the gain may be modest. The point of a custom calibration is a safe, consistent file with proper engine protection, not a number.

What time zone are you in, and how fast is a remote file?

UTC+8, open 10:00 to 20:00. Stage 1 and Stage 2 files are turned around the same day at the fastest, whatever your time zone. Japan is one hour ahead of us, so a datalog sent in the morning gets a revised file the same day.

Can you tune my car remotely?

Yes. You read the ECU with your own flash tool, we send the file, you flash it and datalog. If you have no tool, we can ship one with instructions. You only need a laptop at the car.

Do I need a dyno?

Not necessarily. Dyno tuning is mainly about full-throttle operation; if you have somewhere safe to run full throttle and log, we can calibrate from road logs. A dyno makes it faster and gives you before and after proof.

How do you charge for remote work?

A deposit when we start, the balance before the final file is sent. We do not publish prices here. Tell us the car and the hardware and we quote.

What fuel should I use?

RON 95 minimum for a tuned car. We recommend RON 98 and we calibrate for the fuel you can actually get, so tell us before we start.

Should the gearbox be tuned too?

For Stage 2 and above, yes. More torque needs matching clutch pressure and shift strategy. Low-speed shift shunt is a gearbox calibration issue; no engine file fixes it. Our TCU calibration covers shift points and rpm and speed thresholds, and can be fine-tuned afterwards.

My ECU is locked. What are the options?

Newer ECUs need unlocking before they can be written. Two routes: a bench unlock, or a cloned ECU so your original stays untouched. Which one fits depends on the ECU and the model year. We tell you before any work starts.

Will this hurt reliability or the warranty?

A correct calibration keeps the engine inside its protection limits; that is the whole job, and it is why we log every car. On warranty: a dealer can detect a tune. If that matters, a cloned ECU keeps your original stock. We explain the trade-offs before you decide.

Will the throttle feel or low-rpm drivability change?

Throttle mapping is part of the calibration and can be adjusted to taste; low-rpm torque limits are set per gear. If something feels off after the first file, say so and we revise.

Have you done my model before?

Over 1,000 vehicles across BMW, Audi, Porsche, Honda, Subaru, Toyota and Hyundai, and more than 4,600 calibration files on record: reads, versions, logs and dyno runs. Ask with the model and engine code and we tell you what we have.

What hardware does Stage 2 or Stage 3 need?

Stage 2: intake, a larger intercooler, and water-methanol injection in hot climates. Stage 3: a turbo upgrade with a matching fuel system and intercooler. We help you choose parts that work together, and the hardware list is agreed before the file is written.

Can I go back to stock?

Yes. We keep your original read and can restore it.

Do factory functions stay?

Driving modes, cruise control and the rest stay. A few functions tied to a specific software version can be affected, which is exactly what we fixed on the 1M above. We check and tell you beforehand.

How do I record a datalog?

Use your tool's logger. For a Stage 1 the default channel set is fine; add knock and per-cylinder ignition correction. We send a channel list for your car.

Will a dealer or over-the-air update remove the tune?

Yes. A software update overwrites the calibration. Tell us before a dealer visit and re-flash afterwards.

What software do you use? Is it a canned map?

bootmod3, MHD, MG Flasher, EcuTek, Hondata, KTuner and WinOLS, depending on the platform. The file is written for your car, your hardware and your fuel, and verified on logs. It is not a canned map.

Is English a problem?

English is fine in writing. Japanese works by email with translation. We reply within one working day.

What do you not do?

We do not disable or defeat emissions equipment, and we do not write files for that purpose. Street cars stay compliant with the rules where they are driven.

Contact

Send the car, the hardware and a datalog if you have one. We answer in writing within one working day.

Free datalog analysis

Working on a tuned car and not sure what the log is telling you? Send it. We read it and send back what we see, usually within one working day. No obligation.

Send a datalog
@ ↑